14.5 pin and weld - an experiences with it?

[lazyengineer]

What diameter bit would be used to cut this "channel" on the underside of the muzzle threads and what would be the length of the channel?

Bravo Company, for example, "dimples" their 14.5 stripped barrels. What should the bit diameter and dimple location be for a similar method on 65G?

Thanks for the reply. There is no industry standard, but I have seen muzzle devices commonly come with the hole pre-drilled, just for this. Here's the big Gamma 6.5 one on my Creedmoor. I measure the hole with calipers to be 0.092"


As you can imagine, where that hole specifically lines up along the bottom will vary.