11-18-2020, 07:39 AM
I want to source a pistol barrel. I have not seen something available that is very close, so perhaps I am looking for a custom barrel. Please give your suggestions.
Im near sea level and would like to shoot effectively 0 - 800 yards and achieve around 2 moa at 800 with a handy little 12 ish pistol. Mix of fast shooting and precision shooting. I know this is demanding. Seem feasible?
Is there a reasonable option thats up to it (Monster, or Lilja group buy, etc)?
Or perhaps call Performance firearms and request something like the following laundry list: *I am new to a lot of this so let me know if something doesnt make sense.
- 6.5 Grendel (SAAMI chamber)
- Bartlein blank
- Stainless material - but open to suggestions
- 12.7" barrel length
- Slow-Tapered rear portion
- 0.750" gas block
- Gas block set screw dimples or pin groove?
- 0.068" gas port centered within a rifling groove
- carbine length gas system (7")
- Muzzle threaded 5/8-24
- 11 degree target crown
- oversized (diameter) pinned barrel extension for hand fitting to upper receiver
- M4 style feed ramps
- 3R or 5R CUT easy engraving rifling
- 1:7" twist (129gr ABLR down to 100gr wolf)
- Hand lapped
Open to suggestions to trim fat or optimize specs for what actually matters. Looking to maximize performance but money IS an object (prefer to pay only what is required up to $400 or so). What would you do to achieve my goals above?
Thanks a lot.
Im near sea level and would like to shoot effectively 0 - 800 yards and achieve around 2 moa at 800 with a handy little 12 ish pistol. Mix of fast shooting and precision shooting. I know this is demanding. Seem feasible?
Is there a reasonable option thats up to it (Monster, or Lilja group buy, etc)?
Or perhaps call Performance firearms and request something like the following laundry list: *I am new to a lot of this so let me know if something doesnt make sense.
- 6.5 Grendel (SAAMI chamber)
- Bartlein blank
- Stainless material - but open to suggestions
- 12.7" barrel length
- Slow-Tapered rear portion
- 0.750" gas block
- Gas block set screw dimples or pin groove?
- 0.068" gas port centered within a rifling groove
- carbine length gas system (7")
- Muzzle threaded 5/8-24
- 11 degree target crown
- oversized (diameter) pinned barrel extension for hand fitting to upper receiver
- M4 style feed ramps
- 3R or 5R CUT easy engraving rifling
- 1:7" twist (129gr ABLR down to 100gr wolf)
- Hand lapped
Open to suggestions to trim fat or optimize specs for what actually matters. Looking to maximize performance but money IS an object (prefer to pay only what is required up to $400 or so). What would you do to achieve my goals above?
Thanks a lot.