10-28-2020, 07:01 PM
AlaskaGrendel Wrote:I have the spacer as well. I found it to be ever so slightly longer than it needed to be (in an ACE Skeleton stock) which impeded bolt locking back. Quick diagnosis and quick fix...grabbed a piece of sandpaper and ground down one end a bit. Just shorten it up until you have your desired clearance should you run into the problem. As for what weight... That's up to you. H is the same as your standard ar-15 buffer. H2 heavier, H3 heavier again. I know nothing of 6mm ARC so I got nothin' on that one. With 2 mid-length gas systems, I have used H and H2 with factory and my reloads. Both worked just fine. I prefer the H2. Feels like it cycles more crisp, maybe faster, and definitely changes the recoil impulse. No traditional buffer spring noise.
What I was thinking: Get the H3 SRS & also buy their H & H2 replacement weights. I could switch weights around to see which works best without having to buy 3 different SRS units. Is the spacer polymer or aluminum?
I refuse to be victimized by notions of virtuous behavior.