Textron Systems NGSW Rifle and LMG

[stanc]

You bet your backside it can happen. To date there is not a single polymer or polymer blend that I know of that cant be melted are rendered to a soft placidity state when enough heat is applied directly too it for a given amount of time.

Perhaps I wasn't clear. I was not asking if polymer will melt if it gets hot enough.

I was asking if the polymer cases actually get hot enough to melt in the chamber.

I'm sure they have tested for this, but then again I'm not seeing anyone talk about it.

So you don't really know that the chamber will get hot enough to melt the cases?

And no that bullet in your pic is not sexy in my eyes and it has nothing to do with it being a 6.8 cal.