TM-10 roll pin installed vs set screw, need some ideas
|
TM-10 roll pin installed vs set screw, need some ideas
|
09-19-2020, 10:44 AM
Got it out. I tried to thread a small wood screw into the end of it. That spread the end enough so that a small pair of needlenose got a little bit of grab. Then I tapped the pliers with a small hammer.
Now I can't get the threaded pin to start, since the threads are buggered up. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
TM-10 roll pin installed vs set screw, need some ideas - by phishfood - 09-18-2020, 11:21 AM
TM-10 roll pin installed vs set screw, need some ideas - by Klem - 09-18-2020, 11:42 AM
TM-10 roll pin installed vs set screw, need some ideas - by Old Bob - 09-18-2020, 04:31 PM
TM-10 roll pin installed vs set screw, need some ideas - by phishfood - 09-18-2020, 09:28 PM
TM-10 roll pin installed vs set screw, need some ideas - by phishfood - 09-19-2020, 10:44 AM
TM-10 roll pin installed vs set screw, need some ideas - by Old Bob - 09-19-2020, 03:02 PM
TM-10 roll pin installed vs set screw, need some ideas - by Mad Charlie - 09-23-2020, 09:24 PM
TM-10 roll pin installed vs set screw, need some ideas - by Cowdog - 09-24-2020, 10:24 PM
|
