TM-10 roll pin installed vs set screw, need some ideas
|
TM-10 roll pin installed vs set screw, need some ideas
|
09-18-2020, 09:28 PM
Old Bob Wrote:The bolt catch pin on AR 10s is a combination set screw/catch pin. It unscrews from the lower receiver with a 1/16" hex wrench. This video might help. It's not the best but I think it'll get you where you need to go.Well, now I feel dumb! Now that I know what is supposed to hold it in place, I will know what to do when I finally get this one out. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
TM-10 roll pin installed vs set screw, need some ideas - by phishfood - 09-18-2020, 11:21 AM
TM-10 roll pin installed vs set screw, need some ideas - by Klem - 09-18-2020, 11:42 AM
TM-10 roll pin installed vs set screw, need some ideas - by Old Bob - 09-18-2020, 04:31 PM
TM-10 roll pin installed vs set screw, need some ideas - by phishfood - 09-18-2020, 09:28 PM
TM-10 roll pin installed vs set screw, need some ideas - by phishfood - 09-19-2020, 10:44 AM
TM-10 roll pin installed vs set screw, need some ideas - by Old Bob - 09-19-2020, 03:02 PM
TM-10 roll pin installed vs set screw, need some ideas - by Mad Charlie - 09-23-2020, 09:24 PM
TM-10 roll pin installed vs set screw, need some ideas - by Cowdog - 09-24-2020, 10:24 PM
|
