So I am working on an AR10, and it has a Tactical Machine lower with a rather weird configuration to the area around the bolt catch release. There is only access to one end of the roll pin hole, so I can only drive the pin in, can't get to the other end to drive it back out. It seems as though I have bent the spring over while pushing the release in, and didn't realize that until I had the pin started. And now I can't get the roll pin out.
The pin is only just started into the release, so I do have a bit of roll pin still sticking out of the back. But the way this lower is built, the pin is in a 90 degree corner, without enough room to grab it with vise grips or pliers.
Any ideas?
The pin is only just started into the release, so I do have a bit of roll pin still sticking out of the back. But the way this lower is built, the pin is in a 90 degree corner, without enough room to grab it with vise grips or pliers.
Any ideas?