08-09-2020, 07:41 PM
Heh, did the infill before the Alumahyde had fully cured (another mistake). Might be hard to tell on the STNGR in the sun in that picture, but the safety markings and lower engraving is a bit more obvious. 
Don't think it's too glossy, but it's a bit off on actual Magpul FDE, as you can see by the furniture. Ordered four cans of this stuff a year ago and just now getting around to using it. Only used about half a can so far.
That said, since I rushed it to get it to the range today, I'll be sanding and hitting it again in a few weeks after it's fully cured.
Might even go full redneck and camo it just due to peer pressure. They say never go full redneck, but all my civie hunting buddies camo everything and I get a ration of crap for my mostly monotone rifles. Me, I had to live in and surrounded by camo for so long I now try to avoid it if I can. The hogs and deer never seemed to care, and I doubt any fool breaking into my house will complain much.
And inspiration strikes! I'm going to Hawaiian shirt the crap out of this build!
Don't think it's too glossy, but it's a bit off on actual Magpul FDE, as you can see by the furniture. Ordered four cans of this stuff a year ago and just now getting around to using it. Only used about half a can so far.
That said, since I rushed it to get it to the range today, I'll be sanding and hitting it again in a few weeks after it's fully cured.
Might even go full redneck and camo it just due to peer pressure. They say never go full redneck, but all my civie hunting buddies camo everything and I get a ration of crap for my mostly monotone rifles. Me, I had to live in and surrounded by camo for so long I now try to avoid it if I can. The hogs and deer never seemed to care, and I doubt any fool breaking into my house will complain much.
And inspiration strikes! I'm going to Hawaiian shirt the crap out of this build!