OK, so 2 years ago this was going to be a pistol. I decided I didn't want a pistol, sold the barrel (to Croak) and am on Rebby's Lilja GB #2 for a 16".
Since I have the NiB lower parts kit, I am 2 toning it in black and silver/NiB.
I found a VLTO EMOD at Midway, it was listed as "foliage green". From what people were describing Magpul's Foliage as, I thought it would more greyish.
Of course if I had bothered to look on VLTORs site I would have seen its basically OD. So I tool it apart and spraypainted the base black and some other parts nickel, but I wasn't going to spray the rubber shoulder pad so you can see the original green.
The lower is assembled.
So the parts list is:
Lilja 16"
Maxim bolt
Gas tube carbine melonite
Seekins AGB
Aero Atlas S1 9" Handguard
Noveske Upper
PWA Lower
BCM Gunfighter CH mod 4
BCM Milspec Carbine buffer
VLTOR EMOD Stock
Geissele National Match High-Speed Trigger (bought from Southpaw)
WMD NiB-X Nickel Boron parts kit
Royal Arms Sniper grip
Magpul BAD Lever
AIM surplus NiB Lo-Mass BCG
MD not decided upon.
[ATTACH=CONFIG]16453[/ATTACH]
Since I have the NiB lower parts kit, I am 2 toning it in black and silver/NiB.
I found a VLTO EMOD at Midway, it was listed as "foliage green". From what people were describing Magpul's Foliage as, I thought it would more greyish.
Of course if I had bothered to look on VLTORs site I would have seen its basically OD. So I tool it apart and spraypainted the base black and some other parts nickel, but I wasn't going to spray the rubber shoulder pad so you can see the original green.
The lower is assembled.
So the parts list is:
Lilja 16"
Maxim bolt
Gas tube carbine melonite
Seekins AGB
Aero Atlas S1 9" Handguard
Noveske Upper
PWA Lower
BCM Gunfighter CH mod 4
BCM Milspec Carbine buffer
VLTOR EMOD Stock
Geissele National Match High-Speed Trigger (bought from Southpaw)
WMD NiB-X Nickel Boron parts kit
Royal Arms Sniper grip
Magpul BAD Lever
AIM surplus NiB Lo-Mass BCG
MD not decided upon.
[ATTACH=CONFIG]16453[/ATTACH]