07-02-2020, 05:40 PM
I received mine today. As with y'all, no ship notification and no tracking. Ordered June 13.
I tried some loads I have on hand.
100 ttsx handloads, 2.272, will not fit.
115 Tac-tx, 2.176 (factory) ok.
123 sst factory, 2.238 fits ok.
123 handloads I have on hand, 2.254, they fit just barely. So I stuck a strip of paper in at the noses to see if there's clearance, the paper mic-d at 0.0045", and it slides in -- not a lot of play but it slides in ok.
So maybe 2.258-2.259 max right at the front plastic.
The coal allowable was at first tricky to see, first I measured, from back of plastic to front, was 2.327"....... But.
the way it loads you lose a lot of that in the rear, there's a forward, vertical warp that seats the base, not the totally-at-rear plastic. Hmmm.
Picture of 2.254 sst handload + 0.0045 paper strip:
[ATTACH=CONFIG]16388[/ATTACH]
I tried some loads I have on hand.
100 ttsx handloads, 2.272, will not fit.
115 Tac-tx, 2.176 (factory) ok.
123 sst factory, 2.238 fits ok.
123 handloads I have on hand, 2.254, they fit just barely. So I stuck a strip of paper in at the noses to see if there's clearance, the paper mic-d at 0.0045", and it slides in -- not a lot of play but it slides in ok.
So maybe 2.258-2.259 max right at the front plastic.
The coal allowable was at first tricky to see, first I measured, from back of plastic to front, was 2.327"....... But.
the way it loads you lose a lot of that in the rear, there's a forward, vertical warp that seats the base, not the totally-at-rear plastic. Hmmm.
Picture of 2.254 sst handload + 0.0045 paper strip:
[ATTACH=CONFIG]16388[/ATTACH]
"Down the floor, out the door, Go Brandon Go!!!!!"