05-25-2020, 05:26 PM
Check the feed lips are holding the rounds correctly.
Use 2 rounds, insert one, check to see that the round is sitting in a manner to have the bullet tip pointing up slightly, if that round is good, insert the second.
Tweak the feed lip that needs it to get both rounds pointed slightly upwards.
Other then that take the mags apart, give them a good going over too make sure there's no trash are weld spots are flashing sticking off the follower that's catching.
Almost forgot, might sound dumb but make sure you seat them all the way to the back of the mag.
Use 2 rounds, insert one, check to see that the round is sitting in a manner to have the bullet tip pointing up slightly, if that round is good, insert the second.
Tweak the feed lip that needs it to get both rounds pointed slightly upwards.
Other then that take the mags apart, give them a good going over too make sure there's no trash are weld spots are flashing sticking off the follower that's catching.
Almost forgot, might sound dumb but make sure you seat them all the way to the back of the mag.