05-04-2020, 02:43 PM
gwtx Wrote:Thanks for the replies. Klem, I clean with "carb & intake cleaner" and blow out the primer pockets with high pressure shop air, then set them on fire to burn off any remaining cleaner. This also gets them nice and dry.
after sizing, and I'm pretty sure it is nothing like regular WD40. It leaves no detectable residue. I usually only load 20 rds at a time, and I think I have shot a couple boxes of the loads that were sized with the "dry" stuff. I've not had any failures from it,,,,yet. I may use it on a couple cases and load & shoot'em to see if there is any effect...when time allows.
Grendelshooter, I used that recipe for a while. Lubes great, hard to get it off the inside of the necks, and the spherical powders are drawn to it like a magnet. I really like the OneShot, but hate to pay $20 for a can, even though it lasts a long time. I used the "HEET" fuel additive (99% IPA) when I mixed up my lanolin lube. I did wrinkle a couple cases by allowing too much to build up in the die. Thanks for the reply.
gwtx;
You use a high pressure hose to clean the lube off the brass then burn the brass to get any residual lube removed?
LR55