Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Keep breaking extractors on PLGS BCA 10.5"
#30
worthen86ford Wrote:Even with it choked, Gas is still acting on the bolt sooner than a longer gas system.

Maybe get one of those pigtail gas tubes? Make one out of a rlgs tube? Just tinkering right?

https://www.deltateamtactical.com/Omega-..._4420.html

I always thought these were a gimmick but maybe a solution.

A few years ago at one of our club 3 gun matches a feller showed up to give a demonstration of his pig-tail gas tube installed on a SBR. I think some of our club members bought some but I didn't 'cause I was shooting a 20" barreled AR & had no intention to shoot anything with a shorter barrel at that time. I did get his business card but lost it a long time ago. Guys from our group who shot his SBR said it did seem to smooth out its operation. He also had pig-tail tubes that mimic rifle length systems in carbine ARs. I don't recall if he had a tube for mid-length systems.
I refuse to be victimized by notions of virtuous behavior.
Reply


Messages In This Thread
Keep breaking extractors on PLGS BCA 10.5" - by Old Bob - 04-22-2020, 03:20 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)