04-12-2020, 09:08 PM
GREYBUFF Wrote:Mel,
Just passing an idea along. Looks like you remove your press on a regular basis w/that c-clamp. Another way to do it is take a receiver hitch with a 1/2" nut welded where the pin goes, weld the receiver to the bottom of the bench. Than you can mount your press, case trimmer, vise etc. to a piece of 2" square tube and slide whatever "TOOL" that you currently want into the receiver. Saves lots of space on a work bench. I have this setup both horizontally and vertically (welded to a piece of pipe and concreted in the ground) out in my blacksmith shop and it works great for saving space for vises, grinders, mini anvils etc.
Thats not a half bad idea , i just have it seatclamped for the moment cause i just moved all the reloadi g stuff here from home and i wasnt sure were i wanted the press was trying a few diff spots o. The bench before i drilled holes.
But i may have to use that idea instead