04-12-2020, 08:36 PM
Mel,
Just passing an idea along. Looks like you remove your press on a regular basis w/that c-clamp. Another way to do it is take a receiver hitch with a 1/2" nut welded where the pin goes, weld the receiver to the bottom of the bench. Than you can mount your press, case trimmer, vise etc. to a piece of 2" square tube and slide whatever "TOOL" that you currently want into the receiver. Saves lots of space on a work bench. I have this setup both horizontally and vertically (welded to a piece of pipe and concreted in the ground) out in my blacksmith shop and it works great for saving space for vises, grinders, mini anvils etc.
Just passing an idea along. Looks like you remove your press on a regular basis w/that c-clamp. Another way to do it is take a receiver hitch with a 1/2" nut welded where the pin goes, weld the receiver to the bottom of the bench. Than you can mount your press, case trimmer, vise etc. to a piece of 2" square tube and slide whatever "TOOL" that you currently want into the receiver. Saves lots of space on a work bench. I have this setup both horizontally and vertically (welded to a piece of pipe and concreted in the ground) out in my blacksmith shop and it works great for saving space for vises, grinders, mini anvils etc.
I thought about selling my weapons back to the government, but after a thorough background check it was determined that the buyer has a long history of violence and is mentally unstable. Therefore could not pass NICS.