03-31-2020, 05:16 AM
20 inch go rifle gas and whatever is the correct port size
Go with a pencil are what x-caliber calls spaghetti profile.
Go with the high pressure bolt design with the small dia fireing pin hole, standard 308 bolt is a pain in the butt in 6.5 creedmoor.
SS for the barrel is fine for a hunting rifle barrel.
8 twist is standard for 6.5mm bore but I would rather have 7.5 twist myself
DPMS is the pattern you want.
Ofcourse 5_8x24 thread pitch for muzzle devices.
A slightly large dia extention, so people could do a heat and freeze compression fit would be very much to my liking.
Sidenote for the bolt ditch the rubber oring under the extractor. Even on the grendel bolts as well.
Go with a pencil are what x-caliber calls spaghetti profile.
Go with the high pressure bolt design with the small dia fireing pin hole, standard 308 bolt is a pain in the butt in 6.5 creedmoor.
SS for the barrel is fine for a hunting rifle barrel.
8 twist is standard for 6.5mm bore but I would rather have 7.5 twist myself
DPMS is the pattern you want.
Ofcourse 5_8x24 thread pitch for muzzle devices.
A slightly large dia extention, so people could do a heat and freeze compression fit would be very much to my liking.
Sidenote for the bolt ditch the rubber oring under the extractor. Even on the grendel bolts as well.