03-12-2020, 03:51 AM
FLShooter,
switching wheels on the annealeez is not a big problem. but good to have both a socket (deep socket) and a combo wrench so you can get on both ends of the one bolt. you do not need to gorilla cinch the wheels down, as they don't have much drag load on them at all. set the bottom notch at 12:00 and the top one about 4PM. play with that little paddle thing that varies the space between the two wheels for the case to sit. if it's not right for the case they can fall through and off the bottom wheel. run about two dozen through without flame to make sure that the feeding is working properly before you setup to anneal.
-tdbru
switching wheels on the annealeez is not a big problem. but good to have both a socket (deep socket) and a combo wrench so you can get on both ends of the one bolt. you do not need to gorilla cinch the wheels down, as they don't have much drag load on them at all. set the bottom notch at 12:00 and the top one about 4PM. play with that little paddle thing that varies the space between the two wheels for the case to sit. if it's not right for the case they can fall through and off the bottom wheel. run about two dozen through without flame to make sure that the feeding is working properly before you setup to anneal.
-tdbru