02-21-2020, 02:15 AM
(This post was last modified: 03-10-2020, 10:04 AM by Mustangfreek.)
Ok. Picked up hardly used BA 16? grendel barrel. Upon measuring I found the gas port to be smaller then .070 (have measured with a drill bit #50- .070 ) and it slides right in.
Emailed BA and they were not helpful and actually never said anything about helping out or drilling it out. As I asked. So screw them at the moment..
Just a fun gun, will be shooting 123?s and wolf mostly. no suppressor at the moment. Or anytime soon.Until I get back up and reloading I am shooting factory stuff
So I have 2 other drill bits 48 & 49 ( .073 & .076 )
Don?t really wanna mess around too much.
Thinking of going .076 right off the bat, ya , na ?
Emailed BA and they were not helpful and actually never said anything about helping out or drilling it out. As I asked. So screw them at the moment..
Just a fun gun, will be shooting 123?s and wolf mostly. no suppressor at the moment. Or anytime soon.Until I get back up and reloading I am shooting factory stuff
So I have 2 other drill bits 48 & 49 ( .073 & .076 )
Don?t really wanna mess around too much.
Thinking of going .076 right off the bat, ya , na ?