02-16-2020, 09:03 PM
I worked through each part to find it was the milled in sections of the action. The lil sections were you would attach the CZ scope rings.
I have a DIP rail on it and It was throwing it off even worse. Don't know why I didn't catch it before today.
I was able to fix it by adjusting the torque on the set screws in the DIP 25 moa rail. It's nice and level and I'm at the range now.
Once I figured out that I could level off the rail section by adjusting the torque. I pulled each screw and coated them in rockset and made sure it stayed level.
Back up and shooting now. Will let it roll like this for a bit and see how it goes. If it acts up again. It's either getting milled and tapped are it's going find a new home.
I have a DIP rail on it and It was throwing it off even worse. Don't know why I didn't catch it before today.
I was able to fix it by adjusting the torque on the set screws in the DIP 25 moa rail. It's nice and level and I'm at the range now.
Once I figured out that I could level off the rail section by adjusting the torque. I pulled each screw and coated them in rockset and made sure it stayed level.
Back up and shooting now. Will let it roll like this for a bit and see how it goes. If it acts up again. It's either getting milled and tapped are it's going find a new home.