02-13-2020, 03:53 AM
ricsmall Wrote:You need the JP 3.5T springs. Grind down top rear of trigger that engages safety. Grind about .040-.050” off. Install set screw through pistol grip bolt hole to take up creep. Takes about an hour total and $12. If you have experience stoning trigger surfaces you can also stone with a white India stone and really make it nice. I do this on my utility carbines/pistols. Target guns get Jard fully adjustable.
Ricsmall speaks truth.
I have done up a few Anderson NB triggers with the low power springs and trigger adjustment screw sold at joeboboutfitters and it does make for a perrty nice single stage.
If done right it will come out in the 2 1/2 pound range. Used one for a bit and it ran the wolf ammo just fine.
If you can swing the money a true 2 stage like the Larue are the ssa-e is going to be the best of both worlds. Eats cheap steel cased and nice and smooth light breaking for more serious target/hunting work.