02-08-2020, 04:20 AM
Daveycrockett Wrote:Yea that's why I chose this one after lots of research. Weather in Va ....if you dont like it wait until tomorrow...lol
I used the smallest rubber shim it came with. It actually fit perfectly. I had no issues with it at all...knock on wood.
I'm running it in my AR so I started at the low end of the chart and worked up just to see. I had no pressure signs at all at the end so I might go a tad higher next time.
I have another set already loaded with TAC but my fingers got too cold to run it. The field was too wet to drive so I had to walk to my shooting range.
I don't start anything lower then 25 grains. Just seems like a waste of product. Considering the vast majority of powders used in the grendel end up in the 27.5 to 30 grain range for loads.
Don't go over 28.5 with 8208. For what its worth I don't use 8208 and never will but 28.5 is a well established max on this fourm for 123 to bout 100 grain bullets.
I'm in love with ar-comp,h4895 and h332. Planning on getting rid of all my other powders.