01-29-2020, 03:43 AM
Mel,
one other thing to check. firing pin tip protrusion. i'm sure there's a spec somewhere. it might be just a stack up of tolerances, bolt length from the face to the tail being on the short side, firing pin length from the stop flange to the tip being on the long side. combination will give too much firing pin protrusion length. the mfgr should have a spec. see if that's it.
-tdbru
one other thing to check. firing pin tip protrusion. i'm sure there's a spec somewhere. it might be just a stack up of tolerances, bolt length from the face to the tail being on the short side, firing pin length from the stop flange to the tip being on the long side. combination will give too much firing pin protrusion length. the mfgr should have a spec. see if that's it.
-tdbru