01-19-2020, 11:46 PM
kmon Wrote:Haven't read the whole thread but A5 are you running polymer mags or steel mags? Reason I am asking is the Polymer mags tend to be thicker with a little less internal capacity than steel, at least in many instances. If not running Steel mags, your might give them a try if available before abandioning the project
No one makes metal mags for the six8 revivers. Only mags that are made for it is the six8 pamgs.
Like I stated they work fine with factory ammo but the sized reloads are just a bit more then it can take.
Might take one out to the shop and see if I can mill off say 5 to 10 thousands from the running surface of the guide rails and see if that will allow enough room to let the sized cases of my reloads fees properly.
The guide rails aren't rounded like in normal mags, their running surface is flat. So it maybe possible to mill off just a hair from each one and relieve the pressure from my sized cases.
As to the internal capacity of the polymer mags, they and the magwell are designed to allow a coal length of 2.300.