01-08-2020, 04:31 PM
SightedIn Wrote:Ok so i just finished adjusting the die again but i still cant get a consistent bump. Went all the way out then went back in one tiny increment at a time starting at fireformed 1.211? Got to 1.211? then 1.210? then 1.209?, but then anything past that and its all over the place. Same adjustment and brand brass (hornady) but sometimes it will bump to 1.209? but then sometimes bumps to to as low as 1.201?. No matter how much i fiddle with the adjustment it just wont stay consistent past a .002? bump
I think the remaining may be the either the press or the lube or both as you guys suggested. They are the only variables left.
Finally an excuse to the old lady to buy that T7 ive always wanted!
If you fire formed them to 1.211. Why can't you just push them back to 2.010-2.09 and call it good? Did I read it right that you had success with just this little bump?