Gas Block and Handguard Clearance
|
Gas Block and Handguard Clearance
|
12-15-2019, 08:08 AM
Is the handguard are you using M-Lock accessory compatible (rails & stuff)? I ask, because when I installed a M-Lock Harris bipod adaptor to my MI handguard, one of the screws was too long & made contact with the gas block. I had to grind down the screw a bit to get clearance.
I refuse to be victimized by notions of virtuous behavior.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Gas Block and Handguard Clearance - by flyby71 - 12-08-2019, 01:42 PM
Gas Block and Handguard Clearance - by A5BLASTER - 12-08-2019, 01:57 PM
Gas Block and Handguard Clearance - by FLshooter - 12-09-2019, 02:19 AM
Gas Block and Handguard Clearance - by flyby71 - 12-09-2019, 04:04 AM
Gas Block and Handguard Clearance - by Old Bob - 12-15-2019, 08:08 AM
Gas Block and Handguard Clearance - by flyby71 - 12-16-2019, 09:17 PM
|
