E-Lander magazine problems

[A5BLASTER]

Thanks for the feedback, but i mean what exactly did you do to them - did you open them up, where and how much?

This will be kind of long winded but this is how I tweak mag feed lips.

Take 2 rounds. Brass are steel case doesn't matter.

Insert the first round and look to see how the feed lip contacts the case body. Your looking for complete contact the length if the feed lip and the bullet tip should be slightly above level.

Bend the feed lip as needed to get it to contact fully and have a slight upward angle to the bullet tip.

Once that's done. Insert the second round and repeat as needed.

The few CPD mags I had to do this too. It was always the right side feed lip that was the problem.

Hopefully this could fix your issue. I didn't buy a tool to do the work, I just used some needle nose plyer's I had laying around my work bench.