12-07-2019, 01:22 PM
CFE design is copper fouling eraser... but it tends to be a carbon-istic powder residue.
So looks "dirty". I don't think, in its case, that it is a result of incomplete combustion.
I've also noticed that CFE works best when loaded up close to max, however, max may not be an accurate node for your barrel.
Hornady factory loads also seem to leave a lot of carbon on the brass, at least IMO.
So looks "dirty". I don't think, in its case, that it is a result of incomplete combustion.
I've also noticed that CFE works best when loaded up close to max, however, max may not be an accurate node for your barrel.
Hornady factory loads also seem to leave a lot of carbon on the brass, at least IMO.
"Down the floor, out the door, Go Brandon Go!!!!!"