Steel targets for 1000 yards

[mel]

i built my gongs out of scrap laying around at work
2 steel fence posts cut in half one piece of scrap 1 inch square tubing and a 20 inch diam disc off one of our pieces of equipment (disc)
i end up welding in some roundstock plugs in the center holes so theres not a hole in it
not sure what the steel is made out of but its only 3/16's thick and holds up even to my creedmoor at close range


this was before i made one into a gong and shot it with the creed at 250 ish yards to see if it would even hold up


im actually going to see if i can cut them down to 15 and 12 inch in diam with the plasma or oxy torch since i can hit them consistently at 1100-1200 yards
https://www.youtube.com/watch?v=ALYtlp8nCrg