11-14-2019, 03:16 PM
The current AA mags are E-Lander. I suggest you take the floor plate off and remove the follower and spring. You should be able to visually inspect the seam and welds on the inside of the mag body. If there are rough spots you might be able to file off the rough spots or try to return defective mags to vendor. I’d also inspect the follower for excess plastic from molding and remove. The follower should move up and down in the body smoothly.
There have been reports of the front seam on some of the E-Lander mags being spot welded out of alignment which pretty much makes the mags unserviceable. If your mags have this problem I’d contact the vendor who sold them to you. Brownell’s, LaRue Tactical and AA have been very good about replacing defective E-Lander mags.
There have been reports of the front seam on some of the E-Lander mags being spot welded out of alignment which pretty much makes the mags unserviceable. If your mags have this problem I’d contact the vendor who sold them to you. Brownell’s, LaRue Tactical and AA have been very good about replacing defective E-Lander mags.