09-17-2019, 02:40 AM
Klem or anyone.....I am using a group buy bolt and 16" GB Barrel...…..ejecting violently....small dent on each case but the Fed. case dents are cracked slightly...Hornady cases are just slightly bent at the mouth of course. The ejector pin is so tight I can't remove it with a bench block and correct roll pin punch???? I just sent a pic of a .893 6 shot group to the GB Master Monster with the Fed 90g. TNT factory rounds so shooting in nicely. But the Fed cases are ruined for reloading and the Hornady cases are suspect till I resize and trim them. I have spare plungers and springs BUT the roll pin on one end looks to be chipped or broken during installation and may be the reason this pin is stuck in the bolt. HELP Please