09-14-2019, 10:53 PM
A5BLASTER Wrote:I wish you lots of luck on this project. But I will have to pass. I'm not much on Lee dies.
The Lee Collet die is not a run of the mill die. It only does one thing. It swages the neck around a hard steel mandrel with enough force to flow the brass. Produces a very uniform neck and neck tension. It is traditionally used for a bolt gun where you can get by with neck sizing only but I have found it to improve brass even when full length sized. I use it on fresh home made blackout brass. Cuts groups size in half.
I make the #TTFPowderStand for the Lee Classic Turret press