08-17-2019, 05:54 PM
Put the spring into the magazine release and then install the slave pin to hold the two parts together. The slave pin should be no longer than the magazine lever is thick and the spring will not be in compression.
Slide the assembly into the magwell, as you put tension on the spring the slave pin will hold the spring in place in the lever.
Push the lever and spring into place until the hole lines up, then push the factory pin through the hole pushing the slave pin out the other side.
Slide the assembly into the magwell, as you put tension on the spring the slave pin will hold the spring in place in the lever.
Push the lever and spring into place until the hole lines up, then push the factory pin through the hole pushing the slave pin out the other side.