07-21-2019, 06:24 PM
The sure fire way would be too add material to the mag lips at the area of the case just forward of the case lip. That would give the need angle increase.
But that would have to be done during the forming of the mag. I can't pull that off.
So I'm thinking with some well thought out tweaks and testing the follower may be the answer.
As it sits right now. The mags feed fine and the fact that the bullet tips struck the front lip and carved a lil feed ramp in the polymer of the mag doesn't bother me in the least.
But I know others may be bothered by this so trying to see if I can fix that issue.
Test, tweak, break, rebuild, repeat till it works.
But that would have to be done during the forming of the mag. I can't pull that off.
So I'm thinking with some well thought out tweaks and testing the follower may be the answer.
As it sits right now. The mags feed fine and the fact that the bullet tips struck the front lip and carved a lil feed ramp in the polymer of the mag doesn't bother me in the least.
But I know others may be bothered by this so trying to see if I can fix that issue.
Test, tweak, break, rebuild, repeat till it works.