6.5 Grendel Forum › GENERAL FIREARMS DISCUSSION › Optics, Accessories, Parts, and Equipment v
Ballistic Reticles

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Ballistic Reticles
Bob Duncan
Unregistered
 
#12
04-21-2011, 09:12 PM
The Exbal ballistics calculator has a reticle analysis function. It produced the data below for the Vortex drop-dead bdc reticle. The "holdover" values are per Vortex for each dot below the crosshair. I have not tested these numbers yet. I did use this method on a Leupold VX-3 with a varmint hunters reticle and at 400 yards the POI was within 1/2 MOA of the POA. FWIW


ZERO MIN MAX MOA
BAR (yd) (yd) (yd) Holdover
(x-hair) 200 177 217 0
1 257 242 270 1.5
2 358 350 367 4.5
3 450 443 455 7.5
4 545 540 550 11
Reply


Messages In This Thread
Ballistic Reticles - by Appalachian - 04-09-2011, 03:29 PM
Ballistic Reticles - by Anschutz - 04-10-2011, 02:17 AM
Ballistic Reticles - by Appalachian - 04-10-2011, 03:38 AM
Ballistic Reticles - by Drifter - 04-10-2011, 03:42 AM
Ballistic Reticles - by LR1955 - 04-10-2011, 12:37 PM
Ballistic Reticles - by Drifter - 04-10-2011, 02:04 PM
Ballistic Reticles - by sloan - 04-12-2011, 09:00 AM
Ballistic Reticles - by VASCAR2 - 04-12-2011, 05:58 PM
Ballistic Reticles - by ARMANIAC - 04-13-2011, 01:16 AM
Ballistic Reticles - by JASmith - 04-13-2011, 01:53 PM
Ballistic Reticles - by Bicyclewrench - 04-21-2011, 04:21 AM
Ballistic Reticles - by Bob Duncan - 04-21-2011, 09:12 PM
Ballistic Reticles - by usar_ds - 05-01-2011, 07:36 AM
Ballistic Reticles - by JASmith - 05-01-2011, 05:25 PM
Ballistic Reticles - by usar_ds - 05-01-2011, 05:55 PM
Ballistic Reticles - by bwaites - 05-01-2011, 06:26 PM
Ballistic Reticles - by usar_ds - 05-01-2011, 08:24 PM
Ballistic Reticles - by JASmith - 05-02-2011, 02:31 PM
Ballistic Reticles - by usar_ds - 05-03-2011, 04:26 AM
Ballistic Reticles - by LR1955 - 05-03-2011, 11:55 AM
Ballistic Reticles - by usar_ds - 05-04-2011, 01:57 AM
Ballistic Reticles - by LR1955 - 05-04-2011, 03:15 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)