03-16-2019, 12:19 PM
On that mag you have, take a Dremmel tool, (or Harbor Freight if you are like me), and file down the front flat section below where the bullet feeds. Look for an uneven surface where the metal overlaps. I did this to two ASC mags and three out of four Elanders I bought from Alexander Arms due to misfeeds. All but one mag now works. Don't forget to load that mag up and let it sit for a week or two also.
Check out this link on fixing feed issues.
https://www.youtube.com/watch?v=0Axr5m1Daxc
Do not take the mag down quite as far as this guy does. Only take it down and file the edge smooth until you get what you want.
I know! You shouldn't have to do these things but................................
Check out this link on fixing feed issues.
https://www.youtube.com/watch?v=0Axr5m1Daxc
Do not take the mag down quite as far as this guy does. Only take it down and file the edge smooth until you get what you want.
I know! You shouldn't have to do these things but................................