Help...failure to extract a spent round

Linear Mode

Help...failure to extract a spent round

Sojorboy Offline

Senior Member

Posts: 252
Threads: 28
Joined: Nov 2011

#16

01-30-2012, 02:31 AM (This post was last modified: 02-05-2012, 06:33 PM by Sojorboy.)

I've been doing a little research and found a few things I would like to run by you guys. Is it possible too much gas is causing the ejector clip to jump the case rim because the excess gas is driving the bolt back before it should ? Or maybe a weak extractor spring ?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Help...failure to extract a spent round - by Sojorboy - 01-28-2012, 01:08 AM

Help...failure to extract a spent round - by Drifter - 01-28-2012, 01:28 AM

Help...failure to extract a spent round - by Sojorboy - 01-28-2012, 01:57 AM

Help...failure to extract a spent round - by LRRPF52 - 01-28-2012, 05:51 PM

Help...failure to extract a spent round - by Sojorboy - 01-28-2012, 06:35 PM

Help...failure to extract a spent round - by bwaites - 01-28-2012, 06:35 PM

Help...failure to extract a spent round - by bwaites - 01-28-2012, 06:42 PM

Help...failure to extract a spent round - by Sojorboy - 01-28-2012, 07:36 PM

Help...failure to extract a spent round - by bwaites - 01-28-2012, 08:06 PM