PSA Adjustable Gas Block Questions.

[NeilVT79]

Thanks Neil. I have both screws loose and adjustable. Now I will go back to the drawing board with testing. I ‘assume’ if I was having cycling issues, and not locking back in last round(better now) I would want the ‘gas adjustment screw’ all the way in? ‘Full gassed’?

Just trying to get to coyote hunting reliability

No prob. Here's what I do:

With the gas adjustment screw all the way IN(clockwise) your bolt will not cycle, however, its a good place to start. Load one round in the magazine and fire, if the bolt does not lock back on the empty mag turn the adjustment screw OUT(counterclockwise) one full turn. Load one round in magazine and check if it locks back on the empty mag again. If not turn one more full turn and repeat until it locks back on an empty mag, then I like to turn it out a half turn and tighten the set screw. Run a few different loads to make sure it functions with all your ammo.
Hope this helps.