12-12-2018, 04:13 AM
BTW, I got my barrel out of the receiver. Took a bit of heating with my hot-air gun, but I could finally pull that handguard off the nut. LOL This will make the job so much easier.
6.5 Grendel Forum
›
6.5 GRENDEL DISCUSSION FORUMS
›
6.5 Grendel Build-It-Yourself & Custom Builds
Advice on polishing out some light chamber burrs at the shoulder-neck edge
Advice on polishing out some light chamber burrs at the shoulder-neck edge
|
Advice on polishing out some light chamber burrs at the shoulder-neck edge
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Advice on polishing out some light chamber burrs at the shoulder-neck edge - by SDW - 12-01-2018, 03:39 PM
Advice on polishing out some light chamber burrs at the shoulder-neck edge - by A5BLASTER - 12-01-2018, 03:55 PM
Advice on polishing out some light chamber burrs at the shoulder-neck edge - by SDW - 12-01-2018, 05:49 PM
Advice on polishing out some light chamber burrs at the shoulder-neck edge - by A5BLASTER - 12-01-2018, 06:28 PM
Advice on polishing out some light chamber burrs at the shoulder-neck edge - by SDW - 12-01-2018, 07:21 PM
Advice on polishing out some light chamber burrs at the shoulder-neck edge - by A5BLASTER - 12-01-2018, 07:55 PM
Advice on polishing out some light chamber burrs at the shoulder-neck edge - by SDW - 12-01-2018, 09:03 PM
Advice on polishing out some light chamber burrs at the shoulder-neck edge - by SDW - 12-12-2018, 04:13 AM
|
Users browsing this thread: 1 Guest(s)