11-26-2018, 10:40 AM
Welcome to the Horde.
I had heard that Boyds fixed their milling for the Howa bottom plate, but would not hurt to check. Pull your action screws out and just put finger pressure on the rear, then just the front, and see if the opposite side lifts off the stock.
http://www.65grendel.com/forum/showthrea...ht=fitting
I had heard that Boyds fixed their milling for the Howa bottom plate, but would not hurt to check. Pull your action screws out and just put finger pressure on the rear, then just the front, and see if the opposite side lifts off the stock.
http://www.65grendel.com/forum/showthrea...ht=fitting
Sticks
Catchy sig line here.
Catchy sig line here.

