11-16-2018, 03:58 AM
The E-Lander is even easier to take apart then the C-Products/ASC mag. If you look at the floor plate, you’ll see a triangular tab protruding from the middle. If you take a small screwdriver or allen/torx wrench (I usually use a T15 that I have in the safe for scope mounts) you can press this tab back up into the magazine body. You might have to shift it around a little bit or give it a little pressure, it can be a little sticky. Once this tab is clear of the floor plate, use your wrench/screwdriver to slide the plate off. The plate will only go one way due to the taper on one side. It’s actually a lot easier to do than it is to explain. Good luck!