10-19-2018, 05:01 PM
Just picked up a box of Barnes 120 gr Match Burners and sent them an email asking for load info since it isn't on their website and isn't in QuickLoad.
Basic measurements I put in QL:
Length 1.175"
Small diameter of tail: 0.230"
Length of taper: 0.120
Resulting angle 8.1 deg
pressure ring diameter of .2645"
Barnes reports G1 of .460
Using Hdy seating length tool in BCA upper:
Barnes 120 MB 2.214" Max OAL
PRVI 120 HPBT 2.262"
Hdy 123 Amax 2.261"
Blem 129 Red tip 2.33"
Basic measurements I put in QL:
Length 1.175"
Small diameter of tail: 0.230"
Length of taper: 0.120
Resulting angle 8.1 deg
pressure ring diameter of .2645"
Barnes reports G1 of .460
Using Hdy seating length tool in BCA upper:
Barnes 120 MB 2.214" Max OAL
PRVI 120 HPBT 2.262"
Hdy 123 Amax 2.261"
Blem 129 Red tip 2.33"