6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel ARs and Other Semi-Autos v
trouble zeroing ne grendel build

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
trouble zeroing ne grendel build
grayfox Offline
Posting Freak
*****
Posts: 4,287
Threads: 156
Joined: Jan 2017
#20
09-26-2018, 01:27 PM
I do have a couple of barrels/rifles that don't do the factory sst's very well, but I have been able to get sst+ cfe223 and AR-comp hand-loads to do well, around 3/4-1" when I'm steady. But roger on the factory, it is finicky.
"Down the floor, out the door, Go Brandon Go!!!!!"
Find
Reply


Messages In This Thread
trouble zeroing ne grendel build - by Superfly - 09-25-2018, 12:23 AM
trouble zeroing ne grendel build - by Bigs28 - 09-25-2018, 12:27 AM
trouble zeroing ne grendel build - by Superfly - 09-25-2018, 12:28 AM
trouble zeroing ne grendel build - by A5BLASTER - 09-25-2018, 12:38 AM
trouble zeroing ne grendel build - by grayfox - 09-25-2018, 01:06 AM
trouble zeroing ne grendel build - by rabiddawg - 09-25-2018, 01:15 AM
trouble zeroing ne grendel build - by s3silver - 09-25-2018, 01:21 AM
trouble zeroing ne grendel build - by Klem - 09-25-2018, 01:45 AM
trouble zeroing ne grendel build - by Sticks - 09-25-2018, 09:32 AM
trouble zeroing ne grendel build - by LR1955 - 09-25-2018, 12:14 PM
trouble zeroing ne grendel build - by Popeye212 - 09-25-2018, 04:00 PM
trouble zeroing ne grendel build - by bj139 - 09-25-2018, 05:22 PM
trouble zeroing ne grendel build - by 1Shot - 09-25-2018, 05:30 PM
trouble zeroing ne grendel build - by grayfox - 09-25-2018, 05:53 PM
trouble zeroing ne grendel build - by Superfly - 09-26-2018, 04:18 AM
trouble zeroing ne grendel build - by A5BLASTER - 09-26-2018, 09:45 AM
trouble zeroing ne grendel build - by LR1955 - 09-26-2018, 12:06 PM
trouble zeroing ne grendel build - by A5BLASTER - 09-26-2018, 12:19 PM
trouble zeroing ne grendel build - by grayfox - 09-26-2018, 01:27 PM
trouble zeroing ne grendel build - by LR1955 - 09-26-2018, 02:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)