09-20-2018, 02:34 AM
Thought I read on this board somewhere that Toolcraft actually only makes bolt carriers. Is this true? If so, then the BCGs they sell for whatever caliber must a situation of them buying someone else's bolts and combining them with their carriers? So this strangeness with Toolcraft BCGs, is it because they're combining them with odd bolts, or because their carriers have something different about them?
Reason I'm asking is that that I have a PSA NiB carrier, which I've heard is sourced from Toolcraft but I have no verification on that. And I've combined it with a BA 6.5G bolt, which is a standard .136" Grendel II type bolt. For the firing pin, I pulled out the one that came with the PSA BCG and put in a Bravo Company pin; just wanted to make sure I am using as standard a setup as possible. Have not test fired it yet. Chambers sized brass fine though and I plan to make a couple of dummy rounds for a fit and cycling test.
Reason I'm asking is that that I have a PSA NiB carrier, which I've heard is sourced from Toolcraft but I have no verification on that. And I've combined it with a BA 6.5G bolt, which is a standard .136" Grendel II type bolt. For the firing pin, I pulled out the one that came with the PSA BCG and put in a Bravo Company pin; just wanted to make sure I am using as standard a setup as possible. Have not test fired it yet. Chambers sized brass fine though and I plan to make a couple of dummy rounds for a fit and cycling test.