08-23-2018, 05:46 AM
ok guys so I measured the bolt face depth and it is indeed a .136.. I did the inertia test that BFT spoke of, putting a 123 gr sst with light finger pressure into the chamber turning the barrel upside down and from about three inches letting it thump back down the SST came out sometimes with one thumping sometimes it took two thumping's. did the same thing with the 123 gr American gunner ammo and it did not come back out as easy, it took 3-5 thumping's to get it to fall back out. an interesting side effect I was not expecting,I guess the chamber still had some black marker inside of it from when I colored the two rounds with marker from before to look for where the marker came off at. the American gunner ammo when it came out had little black marker spots all the way around it showing exactly where it was engaged at, the SST had a couple marks also, ill post some pictures as well. where do I go from here guys ? use a finish reamer ? spend some more (no one tell my wife) money on a new barrel ? any thoughts would be appreciated.[ATTACH=CONFIG]12543[/ATTACH][ATTACH=CONFIG]12544[/ATTACH][ATTACH=CONFIG]12546[/ATTACH][ATTACH=CONFIG]12547[/ATTACH]