08-20-2018, 06:04 PM
UPDATE::
First method, i took a brass brush chucked in a drill, doused in clp, and then went in and out for about a minute or two. Reassembled. Not much noticeable difference. Second, ordered some ball hones, and did the same, as suggested by Faxon. Pics attached. Did help but there are still several deep scratches as you can see. So...back to Faxon it goes, for a proper job? Thanks for the help BFT!!
[ATTACH=CONFIG]12525[/ATTACH]
First method, i took a brass brush chucked in a drill, doused in clp, and then went in and out for about a minute or two. Reassembled. Not much noticeable difference. Second, ordered some ball hones, and did the same, as suggested by Faxon. Pics attached. Did help but there are still several deep scratches as you can see. So...back to Faxon it goes, for a proper job? Thanks for the help BFT!!
[ATTACH=CONFIG]12525[/ATTACH]