Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Grendel Magazines
#15
The angle to the feedramps is key. Slo -mo a round going into the chamber, outside pointing in a safe direction!,, put a dot of, say, your gals lipstick on tip of bullet. Adjust feed lips as needed, a small smooth faced crescent wrench and some patience helps tweak the feed lips upward. It's easy..


Make sure it hits center of height and width on feed ramp.
Reply


Messages In This Thread
Grendel Magazines - by Pugsbrew - 07-06-2018, 05:16 PM
Grendel Magazines - by NugginFutz - 07-06-2018, 05:29 PM
Grendel Magazines - by Kswhitetails - 07-07-2018, 01:45 AM
Grendel Magazines - by Tipsymutt - 07-07-2018, 02:38 AM
Grendel Magazines - by robertWperret - 07-07-2018, 12:04 PM
Grendel Magazines - by Popeye212 - 07-07-2018, 12:44 PM
Grendel Magazines - by 1Shot - 07-07-2018, 01:32 PM
Grendel Magazines - by Lastrites - 07-07-2018, 02:23 PM
Grendel Magazines - by joedirt199 - 07-07-2018, 03:17 PM
Grendel Magazines - by cb4017 - 07-07-2018, 03:35 PM
Grendel Magazines - by ErikS - 07-07-2018, 05:57 PM
Grendel Magazines - by Londerko - 07-07-2018, 07:32 PM
Grendel Magazines - by Popeye212 - 07-07-2018, 08:31 PM
Grendel Magazines - by Crusty - 07-07-2018, 09:08 PM
Grendel Magazines - by sneaky one - 07-07-2018, 10:42 PM
Grendel Magazines - by sneaky one - 07-07-2018, 10:46 PM
Grendel Magazines - by rc51crazy - 07-08-2018, 01:35 AM
Grendel Magazines - by A5BLASTER - 07-08-2018, 01:46 AM
Grendel Magazines - by ported45 - 07-12-2018, 06:52 PM
Grendel Magazines - by bob4432 - 07-24-2018, 07:59 PM
Grendel Magazines - by VASCAR2 - 07-24-2018, 08:23 PM
Grendel Magazines - by A5BLASTER - 07-24-2018, 08:32 PM
Grendel Magazines - by Popeye212 - 07-24-2018, 09:40 PM
Grendel Magazines - by Randy99CL - 07-24-2018, 10:36 PM
Grendel Magazines - by Popeye212 - 07-24-2018, 10:52 PM
Grendel Magazines - by bob4432 - 07-25-2018, 12:36 AM
Grendel Magazines - by Kswhitetails - 07-25-2018, 02:34 AM
Grendel Magazines - by RobUrban - 07-25-2018, 03:26 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)