6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Ejected brass dented from deflector

Linear Mode
Ejected brass dented from deflector
VASCAR2 Offline
Posting Freak
*****
Posts: 6,206
Threads: 50
Joined: Mar 2011
#3
06-27-2018, 06:10 PM
You can also push out the roll pin holding the ejector and ejector spring. Cutting a couple of coils off the ejector spring can help keep the brass from getting dented.
Find
Reply


Messages In This Thread
Ejected brass dented from deflector - by DRW - 06-27-2018, 02:45 PM
Ejected brass dented from deflector - by Jakal - 06-27-2018, 02:54 PM
Ejected brass dented from deflector - by VASCAR2 - 06-27-2018, 06:10 PM
Ejected brass dented from deflector - by Mesa1978 - 06-28-2018, 12:53 AM
Ejected brass dented from deflector - by Klem - 06-28-2018, 01:45 AM
Ejected brass dented from deflector - by NCFED - 06-29-2018, 11:28 PM
Ejected brass dented from deflector - by DRW - 07-01-2018, 05:42 PM
Ejected brass dented from deflector - by Melglass - 07-02-2018, 02:17 AM
Ejected brass dented from deflector - by LRRPF52 - 02-04-2019, 06:35 PM
Ejected brass dented from deflector - by JohnXDm - 02-28-2019, 12:21 AM
Ejected brass dented from deflector - by mtnlvr - 04-30-2019, 01:15 AM
Ejected brass dented from deflector - by FRB6.5 - 05-01-2019, 01:57 AM
Ejected brass dented from deflector - by Klem - 05-04-2019, 03:49 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)