6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Extraction and feed problems

Linear Mode
Extraction and feed problems
buck119fa Offline
Junior Member
**
Posts: 6
Threads: 2
Joined: May 2018
#6
06-23-2018, 03:54 PM
Gas port is correct size, already pulled the gas block checked size and verified proper alignment and resealed. I did not skimp on parts for this build. Did that once on another build, never again. I'll look at the extractor directly and report what i find. Thanks
Find
Reply


Messages In This Thread
Extraction and feed problems - by buck119fa - 06-23-2018, 02:22 PM
Extraction and feed problems - by Popeye212 - 06-23-2018, 02:37 PM
Extraction and feed problems - by buck119fa - 06-23-2018, 02:46 PM
Extraction and feed problems - by Kswhitetails - 06-23-2018, 02:55 PM
Extraction and feed problems - by VASCAR2 - 06-23-2018, 03:11 PM
Extraction and feed problems - by buck119fa - 06-23-2018, 03:54 PM
Extraction and feed problems - by buck119fa - 06-23-2018, 04:36 PM
Extraction and feed problems - by buck119fa - 06-23-2018, 10:04 PM
Extraction and feed problems - by Kswhitetails - 06-24-2018, 03:36 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)