bj139 Wrote:Klem,
It looks like your mount may be a board with a 1/4" bolt through the bottom. Is this right?
Yes, no expense spared after forking out hundreds for the radar. A plank of hardwood that was lying around and a screw from my screw-jar that fit. 10"x5"x1"thick. It's the standard thread size for camera tripods, 1/4"-20UNF.
If the rifle range is flat then the tops of the benches will be square to the targets. You just need to pan the radar left and right to aim at a particular target.
I played around with a small tripod when I first got it but a flat stand is way quicker for bench shooting and it puts the microphone exactly at the same level as the barrel (the detection microphones are in the middle on either side of the radar). You can push it closer to the forward edge of the bench without it falling off, which was my fear when using a tripod. I've since added a non-slip rubber surface to the bottom because it would move every time I pushed a button.