6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Sloppy fitting lower.

Linear Mode
Sloppy fitting lower.
stokesrj
Unregistered
 
#2
01-03-2012, 08:19 PM
I know it is counter intuitive, but sloppy fit does not deter accuarcy, but rattling and flexing buggs me too. I've used the accu wedge and the JP cammed pivot pin and glass bedding. If you are going to pair the upper and lower, bedding them is the most satisfactory to me. If you will swap lowers then the JP pin will do the trick but it is a pain to tighten, rquiring a properly fitting screw driver and an allen wrench. If you decide to go that route I have one somewhere I'll sell for 50% of new if I can find it.
Bob
Reply


Messages In This Thread
Sloppy fitting lower. - by K_Labs - 01-03-2012, 05:26 PM
Sloppy fitting lower. - by stokesrj - 01-03-2012, 08:19 PM
Sloppy fitting lower. - by Hektor - 01-04-2012, 04:18 AM
Sloppy fitting lower. - by LRRPF52 - 01-04-2012, 07:55 AM
Sloppy fitting lower. - by K_Labs - 01-04-2012, 08:59 AM
Sloppy fitting lower. - by stokesrj - 01-04-2012, 12:50 PM
Sloppy fitting lower. - by Drifter - 01-04-2012, 12:53 PM
Sloppy fitting lower. - by Jgloveracob - 01-07-2012, 06:27 PM
Sloppy fitting lower. - by Mutt - 01-09-2012, 04:37 AM
Sloppy fitting lower. - by sgt_murf - 01-15-2012, 03:21 PM
Sloppy fitting lower. - by rasp65 - 01-19-2012, 02:26 AM
Sloppy fitting lower. - by usmc1371 - 01-19-2012, 02:53 AM
Sloppy fitting lower. - by stokesrj - 01-19-2012, 03:03 AM
Sloppy fitting lower. - by stokesrj - 01-19-2012, 03:04 AM
Sloppy fitting lower. - by usmc1371 - 01-21-2012, 03:45 AM
Sloppy fitting lower. - by Deezil - 01-21-2012, 06:24 AM
Sloppy fitting lower. - by elkbow - 01-21-2012, 04:01 PM
Sloppy fitting lower. - by rasp65 - 01-22-2012, 08:09 PM
Sloppy fitting lower. - by elkbow - 01-23-2012, 01:45 AM
Sloppy fitting lower. - by jwilson1985 - 01-26-2012, 01:44 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)